Published
This video tutorial will walk you through each step required to configure OSPFv2 between Cisco and Juniper routers to include how to set up MD5 authentication. I also go through all the commands required to perform your verification and we even take a look the Juniper forwarding table to see that Equal Cost Multipathing (ECMP) is not enabled by default. Hope you enjoy!
- Category
- Routers and Switches
Be the first to comment
Up Next
Autoplay
-
05:54
How to configure User Account on Juniper Junos routers/switches, a basic skill for network engineers
-
07:37
How to configure DNS on Juniper Junos routers/switches, a basic skill for network engineers
-
07:16
How to configure Login Class on Juniper Junos routers/switches, a basic skill for network engineers
-
1:28:59
Tutorial: Bridges, Routers, Switches, Oh My! Level: Introductory/Intermediate
-
09:23
IP Address - IPv4 vs IPv6 Tutorial
-
08:29
How to configure DHCP on Juniper Junos routers/switches, a basic skill for network engineers
-
10:30
Juniper, Cisco, Arista BGP route exchange. Juniper vSRX appliance in GNS3 networks (Part 5)
-
08:29
How to configure DHCP on Juniper Junos routers/switches, a basic skill for network engineers
-
08:53
Switches and Routers (Introductory Video) (Part 1 of 2)
-
06:22
How to configure syslog on Juniper Junos routers/switches, a basic skill for network engineers
-
01:59
QSFP28 100G Optical Transceivers in the New Data Center
-
25:20
How much is a 100G QSFP28 transceiver?
-
02:50
How about the feature of QSFP28 QSFP+ SFP+ XFP CWDM DWDM BIDI module? (LD, PD, Tx Power, Rx Sens )
-
02:21
Finisar Demonstrates 100G QSFP28 ER4f Transceiver at ECOC 2017
-
02:12
QSFP28 100G testing between Arista and Huawei
-
01:59
QSFP28 100G Transceivers in the New Data Center
-
04:34
Unboxing and Replace QSFP Broken || JNP QSFP 100G SR4 || SFP Module || Juniper
-
08:25
100G Transceivers Development
-
02:07
QSFP28 100G Transceivers: Key Features and Applications
-
04:09
Finisar QSFP28 Family Transceiver Demonstration at OFC 2015
