Cisco CLI for Beginners | Network Fundamentals Part 10

Skip ad
90 Views

  • Thanks! Share it with your friends!

    You disliked this video. Thanks for the feedback!

admin
Published
Cisco CLI for Beginners | Network Fundamentals Part 10
You’ve been following on for a while, and now it’s time to get your keys dirty by starting Cisco router or switch configuration!

Routers and switches come in different sizes and shapes depending on how they’re used. You might have a devices suited to SOHO, enterprise, or service provider spaces. The thing that’s usually common to all these, is that you can configure them using the CLI (Command Line Interface)

In this video we’ll start by looking at a router physically. You’ll see the console ports (both USB and serial), the data ports, the AUX port, module slots, and single/dual power supplies.

Next, we’ll see how to use a terminal emulator called Putty to connect to the router using a USB Serial Adapter. From here you’ll see user exec mode, global exec mode (AKA privileged exec mode) and configuration mode.

While we’re here, we’ll configure an interface with an IP address, and configure remote access to the router (using SSH).

Finally, we’ll talk about lab options, including physical equipment, GNS3, packet tracer, VIRL and EVEng.

Lab options:
https://www.netacad.com/courses/packet-tracer
https://www.gns3.com/
https://learningnetworkstore.cisco.com/virtual-internet-routing-lab-virl
https://www.eve-ng.net/


The CCENT/CCNA study guide (affiliate): https://click.linksynergy.com/link?id=RL4E*8CmbSY&offerid=145238.2445867&type=2&murl=http%3A%2F%2Fwww.ciscopress.com%2Ftitle%2F9781587205804

In the next video, we’re starting to get deeper, by starting switching!


Overview of this video:

0:00 Introduction

0:52 Physical Overview

5:05 Connecting to the router

8:19 Getting used to the CLI

12:50 Configuring an Interface

17:15 Remote Access

25:11 Running Config and Filesystem

28:08 Lab Options




LET'S CONNECT

Category
Routers and Switches
Be the first to comment